凯发

 028-85758537 
Individual Programming

2016-06-13 15:45:35

Individual Programming

AutoHex II can perform ECU programming/flashing individually.

You must be connected to internet to use this function, because most of the job is done on Server side.

After you select Individual Programming from the left menu, AutoHex software will communicate to Microtronik sever and gets the suitable ECU numbers that fits the vehicle.

After that AutoHex will show you a report of each ECU in this vehicle, the status of the ECU is one of the following:

  • Replace with xxxxxxx: If Ecu not matching the vehicle, Autohex II will show the correct number that should replaced with.
  • Mount xxxxxx: If Ecu is missing, or not responding, you will get this report.
  • Update is available: If Ecu needs update.

To update any ECU in the list of report, it should be compatible with the vehicle (means mounted and not marked for replacement), just select the desired ECU then click on Next as in the picture.

You will get some details about the ECU being flashing, with the following important instructions:

- Battery voltage must remain higher than 13.0V during programming session.

- Ecu(s) marked with (MOST adapter required) must be programmed by AutoHex MOST adapter.

- Turn All car equipments (AC, lights, Radio, Bluetooth...) OFF before your start programming.

- Don't start engine and don't turn ignition OFF while programming.

- Don't disturb the connection between AutoHex II and the car while programming.

- Don't disturb the car while programming.

 

You can then click on next, programming will start.


Programming BMW F Series

 
Autohex BMW Menu

BMW Programming Ecus report
Autohex BMW Ecu Programming

 

<上一篇

第一页

下一篇>

Individual Coding

公司简介 产品介绍 行业资讯 服务项目 培训中心 软件下载 联系我们 免责声明

联系电话: 028-85758537 联系邮箱:1284909852@qq.com 联系地址:成都市双流县大件路白家段车管所大门口
Copyright©成都博通冠达电子科技有限公司  备案号:  蜀ICP备16012544号 技术支持:顶呱呱集团